Using voice commands

The following tips can help you use voice recognition with ClinicalVision more effectively:

GUI - Every GUI item (for example, a link, button, or check box) has a corresponding voice command. The name of the GUI item as it appears is the name the speech recognition engine recognizes.

Recognized commands - When a command is recognized, you will see it displayed in a small box on the screen. If you do not see the command displayed soon after speaking the command, then it might not have been recognized. Try saying it again.

Teeth - Say "Tooth" followed by the tooth number or letter.

Surfaces - Say "Surface" followed by the surface letter.

Roots - Say "Root" followed by the root letter.

Tooth Range - Say "From X to Y," where X is the first tooth, and Y is the second tooth in the range.

Bridge Tooth Type - Say "Type" followed by the type. (for example, "Type Pontic")

Commands with punctuation - The voice commands do not support punctuation. Leave out any punctuation present.

Perio navigation:

To jump to a specific tooth during perio exam say, "Tooth X," where X is the number or letter of the correct tooth.

To jump to a specific surface of the current tooth, say the name of the surface (for example, "Mesial").

Buttons that do not have words:

Periodontal Navigation - >> "Navigation Move Right"

Periodontal Navigation - << "Navigation Move Left"

Periodontal Dir - >> or << "Change Advance Direction"

Page - >> "Next Page"

Page - << "Previous Page"

Skip Tooth (Restorative) - >> "Skip"

Fractions:

"Half"

1 "One and a half"

2 "Two and a half"

Crown "Three quarter crown"

Abbreviated words:

Existing Tx "Existing Treatment"

Perm/Prim "Permanent Primary"

Tipped "Tipped Tooth"

Over/Under Cntr "Over Under Contoured"

Retain "Retained Root"

Spce Maint "Space Maintainer"

Ling Splnt "Lingual Splint"

Cast P&C "Cast Post and Core"

Prefab P&C "Prefab Post and Core"

Apico "Apicoectomy"

Retro "Retrograde"

Suppr "Suppuration"

Seq "Sequence"

Need more help?

You can visit our website or contact OMSVision Customer Support.