Setting up the Jazz Solo sensor

Dentrix Imaging supports acquiring intraoral images from the Jazz Solo intraoral X-ray sensors on computers running the Windows operating system. Drivers for the Jazz Solo sensor must be installed on each computer that the Jazz Solo sensor will be connected to.

Note: Before installing the Jazz Solo sensor, you must install the acquisition agent application on each computer that you use to acquire images. Please refer to Setting up the acquisition agent for instructions on downloading and installing the acquisition agent.

Minimum version

·        Acquisition agent v1.2.8364.x

Installing the Jazz Control Center

To set up the Jazz Solo sensor, you must install the Jazz Control Center.

To install the Jazz Control Center

1.   Download the Jazz Control Center.

2.   Double-click JazzControlCenter.exe.

The Welcome screen appears.

3.   Click Next.

The Custom Setup screen appears.

4.   Click Next.

The End-User License Agreement screen appears.

5.   Select I accept the terms in the License Agreement, and then click Next.

The Ready to Install screen appears.

6.   Click Install.

The Windows Security message appears.

7.   Click Install.

8.   Connect the Jazz sensor to the computer, and wait for the drivers to install.

A message appears.

9.    Click OK.

The Completing the Jazz Control Center Setup screen appears.

10. Click Finish.

A message appears.

11.  Click Yes.

Configuring Jazz Control Center

Once you have installed the Jazz Control Center, you must configure the settings.

To configure the Jazz Control Center settings

1.   Open the Jazz Control Center and confirm that the sensor is connected to the computer.

2.   From the Selected Profile list, select Dentrix Imaging.

3.   Click Open Configurator Tool.

4.   Select Enable 2x2 Binning.

Testing

Once the Jazz Solo sensor is functional, you can test it by acquiring an image.

To acquire an image

1.   In the Imaging Procedures list, click Bitewing Single Image.

2.   In the tooth selection chart, click the teeth you want to image.

3.   In the Acquisition method for this imaging exam menu, click Jazz SOLO, and then click Proceed with Acquisition.

4.   Acquire an image using the Jazz Solo sensor.

Troubleshooting

Ensure that the Jazz Solo sensor is detected by the computer. Open Device Manager, and then verify that the device appears.